CPH24
CPH24 water-based pigment stain, cherry (concentrate)
Pigmented stain: evens out colour variation, hides wood defects, levels well and has good lightfastness. Concentrate: reduce with 400–600 % water (catalog: up to 1000 %), with CFH1 binder. All CPH stains intermix. Can also be used to tint exterior coatings (catalog).
- Staining furniture in any wood species
- Evening out colour variation, masking defects
- Tinting exterior coatings
Mix calculator
Ratio 100 : 500.0
| Component | Weigh out |
|---|---|
| CPH24part A | 83.3 g |
| waterThinner | 417 g |
| Total | 500 g |
Covers roughly 5.56 m² at 90 g/m².
Ask about CPH24
Answers are based on the CPH24 data and the products it mixes with.
Mixing matrix
- waterThinner% by weight: 400–600 %official% by volume: 400–600 %official
Standard dilution per the official page.
- waterThinner% by weight: 400–1000 %catalog
The catalog allows up to 1000 % — for lighter, more see-through tones.
- CFH1Additive% by weight: 0–200 %official% by volume: 0–200 %official
Water-borne stain binder: locks the pigment down, raises less grain, lays down more evenly.
- CFH1Additive% by weight: 10–20 %dealer
Dealer (CPH series): working-mix formula says add CFH1 at 10–20 % of the ready stain for better levelling; the note on the same page says 15–20 %. CPH24/1 already contains 15–20 %.
Different basis from the official 0–200 %: 15 % of a 1:5 ready stain ≈ 90 % of the concentrate.
- CPH (other colours)Additive% by weight: any ratio %dealer
All CPH stains intermix in any ratio (dealer).
| Role | Material | % by weight | % by volume | When |
|---|---|---|---|---|
| Thinner | water | 400–600 %official | 400–600 %official | Standard dilution per the official page. |
| Thinner | water | 400–1000 %catalog | — | The catalog allows up to 1000 % — for lighter, more see-through tones. |
| Additive | CFH1 | 0–200 %official | 0–200 %official | Water-borne stain binder: locks the pigment down, raises less grain, lays down more evenly. |
| Additive | CFH1 | 10–20 %dealer | — | Dealer (CPH series): working-mix formula says add CFH1 at 10–20 % of the ready stain for better levelling; the note on the same page says 15–20 %. CPH24/1 already contains 15–20 %.Different basis from the official 0–200 %: 15 % of a 1:5 ready stain ≈ 90 % of the concentrate. |
| Additive | CPH (other colours) | any ratio %dealer | — | All CPH stains intermix in any ratio (dealer). |
Percentages are per 100 parts of component A.
Characteristics
- Viscosity
- ≈10–13 s DIN4 as diluted (near water; below the DIN4 cup's valid range)recommended
- Drying · Full cure
- 4 hdealer
- Drying · Sand or stack
- 4 hdealer
- Drying · Touch-dry
- 20–30recommended
- Drying · Conditions
- 20 °C
- Lightfastness
- good (qualitative)official
- Levelling
- goodofficial
- Hiding
- high (hides colour variation and defects)catalog
Colours
- CPH24 · Cherry
Application
HVLP
- Nozzle
- 1.0–1.3recommended
- Pressure · air
- inlet 1.8–2.2 (trigger pulled), cap ≤0.7recommended
- Spray viscosity
- ≈10–13 s DIN4 as diluted — do not thicken; (near water; below the DIN4 cup's valid range)recommended
- Consumption
- 80–100 g/m²official
- Wet film
- 80–100recommended
- Coats
- 1 (2nd light coat only to deepen tone)recommended
- Flash-off
- 10–20 before wiping/levelling; 4 h before sealerrecommended
- Recoat
- 4 h at 20 °C before primer/sealerdealer
Spray one even wet coat from 15–20 cm, fan fully open, 50 % overlap. No runs or puddles — pigment collects in pores and on end grain. Stir well before filling (the pigment settles) and strain through a 125–190 µm filter.
Conventional spray
- Nozzle
- 1.0–1.2recommended
- Pressure · air
- 2.0–3.0recommended
- Consumption
- 80–100 g/m²official
Fine for small batches; transfer efficiency only up to ~40 % (methods page).
Airmix (air-assisted airless)
- Nozzle
- 0.18–0.23 (tip 007–009 thou), fan 20–40°recommended
- Pressure · fluid
- 6–12recommended
- Pressure · air
- 1–2recommended
- Consumption
- 80–100 g/m²official
For production runs of panels/mouldings; use the smallest tip — the material is very thin.
Cloth or pad
- Consumption
- 80–100 g/m²catalog
Catalog: 'spray + wipe' — spray on, then immediately wipe with a pad/rag to even the tone and bring out the grain.
Roller
- Consumption
- 10–20 g/m²catalog
Catalog: roller-coater application 10–20 g/m² (roller lines, flat panels only).
Process and compatibility
- Substrate preparation
- Sand P150, P180dealer
- Grain raise
- Pre-wet with clean water, dry 1–2 h, denib P180–P220 before stainingrecommended
- Goes over
- bare wood
- Goes under
- HTL20 SM
- Also goes under
- PU, acrylic, PE and NC primersrecommended
- Sanding
- Do not sand the stain itself; sand the primer at P280–P320dealer
- Temperature and humidity
- 15–25 °C, RH 40–70 %, material and part ≥15 °Crecommended
- Don'ts
- Don't stain over dust or sanding scratches — the pigment will show every one
- Don't seal before 4 h at 20 °C
- Don't sand the stain coat — you'll cut through the colour on edges
- Don't let it freeze
Storage
- Shelf life
- 12 months unopenedrecommended
- Storage temperature
- +5…+30 °C, protect from frostrecommended
- Packaging
- concentrate: 1 / 5 kg (CPH1 sibling at dealer)dealer
Safety: Water-reducible, no organic solvents. Wear gloves; use a P2 particulate mask when spraying. No SDS found — follow general water-borne coating practice.
Mixed into
CFH1 / CPH21 / CPH21/1 / CPH22 / CPH22/1 / CPH23 / CPH23/1 / CPH25 / CPH25/1 / CPH26 / CPH26/1 / CPH3 / CPH6 / CPH60
Sources
Value tags: “official”, “dealer”, “catalog”, “schedule” are Technocolor data; “workshop” is from our own datasheets; “recommended” is our engineering estimate (hover to see the reasoning).
- official: properties, spray 80–100 g/m², water 400–600 %, CFH1 0–200 %
- dealer CPH-series concentrate page (CPH1): working formula water 400–600 %, CFH1 10–20 % of ready stain, full dry 4 h, intermixable
- dealer CPH24/1: system schedule P150/P180 → stain → 4 h → HTL20 SM
- methods page
Not covered by the sources
- solids % (not published)
- density
- lightfastness rating (only qualitative 'светостойкость')
- official TDS / SDS (none found online)
- official spray nozzle/pressure (all derived)
- shelf life (derived)
- dealer page for the CPH24 concentrate itself (only CPH24/1 listed)
- binder CFH1 product page